Suspension bushes are fitted to cars at all points where the vehicle chassis is joined to a moving suspension component. They are fitted to provide a noise and vibration-absorbing barrier between the road and you.
Rubber acts as that sound barrier, damping out noise and vibration. Without them, cars would feel much harsher and noisier. Rubber is also very very cheap.
In general, the answer is no. A lot of racing cars, especially single-seater track-based cars use metal joints which do not provide any noise absorption. The life of these joints is measured in hours. They are not suitable for road use. However, a huge number of racing cars still use rubber bushes. These are either production-based cars adapted for race use or rally cars where the forces on the suspension can be so high that metal joints would break.
If your race car has rubber bushes anywhere in the suspension then fitting POWERFLEX bushes will improve all aspects of its handling. They will outlast rubber by a factor of ten. They will control the geometry much more accurately during rapid suspension movements and they will reduce tyre wear.
Nylon is probably the worst of all worlds. When a suspension arm moves up and down it does not move only up and down but describes an arc. This means that for example an inner track control arm bush will be required to flex in two dimensions at the same time. In this example, a metal bush will allow this movement as will a rubber or POWERFLEX bush. However, a nylon bush will allow up and down movement but 100% of the arc loadings will be transferred into the arm and the chassis. This causes arm flexing and can easily cause premature arm failure! Of course, nylon has no vibration-absorbing characteristics at all, so all vibration is transferred up the already highly stressed arm.
Cost, availability and marketing. Polyurethane, as a raw material, is about ten times the cost of rubber plus it is more expensive and slower to process. Car manufacturers buy a lot of components. If Ford decided to use polyurethane bushes in their range of cars they would need to find a supplier capable of making literally millions of bushes a year. There is no company in the world (even EPTG Ltd) that could make those sorts of quantities. Cars are all about marketing. As long as the standard rubber bushes work without serious failure for two or three years then the manufacturer is happy. Would fitting polyurethane bushes make you buy one car in preference to another make? Probably not.
POWERFLEX bushes improve your cars’ road holding and chassis performance by controlling the amount of unwanted flex in the suspension. This means your suspension is doing what it is supposed to. It means your tyres have greater contact with the road at all times, therefore, improving safety and performance. Correctly formulated polyurethane is as good if not better at noise, vibration and harshness suppression when compared to rubber.
For exactly the same reason as above but with a different emphasis. If your tyres are in better contact with the road and your suspension movements are being controlled more accurately then tyre wear will be dramatically reduced. We have letters of recommendation from customers who state that they have doubled the life of their tyres on certain cars after fitting POWERFLEX bushes. We are not claiming that you will get this but worn bushes are dangerous and will be costing you money due to premature tyre wear. Have you ever taken your car into a tyre shop with tyres that are worn out on the inner or outer edges but perfectly legal everywhere else? You assume the tracking is wrong, but when the shop checks, it is correct. This is bush wear. When the car is stationary the tracking is correct but as you move and the loads increase then the tracking goes out. Come to a stop and the tracking is right again. Worn bushes.
Another major advantage of POWERFLEX bushes is life. Rubber is a natural product and deteriorates with age, especially on cars that are not being used regularly. The bushes will crack on the outer surface and soften inside. POWERFLEX bushes are not affected by ultraviolet, petrol, oil, battery acid, water or time. Perfect for your loved one. (And the car!)
Typically about 5 to 8 times the cost of a standard rubber bush. However, that is not the whole story. When you consider the cost of fitting new bushes and the fact that POWERFLEX will be the last bushes you ever fit to your car things start to look a bit better. Then consider tyre wear, a real cost saving here. Car manufacturers have a habit of not supplying the bushes alone, only supplying them complete with suspension arms. Paying £70 for an arm when a POWERFLEX bush might cost £15 is not a good idea. And finally, as cars get older manufacturers stop supplying certain parts. Imagine your car was off the road because of a bush failure. You go to the parts shop and the part is “no longer serviced”! POWERFLEX makes a lot of sense then.
We design all the bushes so that they can be fitted without special tools. However, sometimes it is a lot harder to remove the old bushes than fit the new ones. If you feel you have very little mechanical knowledge, experience, talent or tools, either ask a friend or get them professionally fitted.
We design all bushes using highly accurate measurements taken from genuine OE parts as fitted to the vehicle from new and as a result, our parts may not fit aftermarket suspension components if they differ from standard. With this in mind, if you do have Non-Genuine suspension arms etc. fitted to your vehicle, we would always advise checking sizing before ordering.
Our Road Series and Heritage Collection kits can use a mix of all 4 of our materials. During the development stages, we test the original bush and see what the requirements are for strength and movement. At that point, we then decide which of our materials would be best suited. We don’t believe in a one material suits all rule. Manufacturers will do the same and will use different shore rubbers, however, it’s not as noticeable as all rubber bushes look visually similar.
Some areas of a modern vehicle’s suspension system are under high stress and load and the OE rubber bushes will be extremely stiff from the factory as a result. This means that even on normal road vehicles, the suspension requirements will mean that a 95A shore compound is best suited. In these instances, the bushes in your pack will be Black in colour regardless of which range you have ordered them from.
While our Road Series bushes are traditionally associated with being the Purple colour, they can in fact be Red, Yellow, Purple or Black depending on where they are to be fitted on the vehicle and the task required of them.
You can find out more here.
They are distributed by a whole host of quality car parts stockists all over the world. Please contact us if you cannot find a suitable stockist on this site.
No, but it depends on the car. Some cars benefit more than others. But there is a fair amount of effort involved in changing bushes so consider changing, for example, a front set at one time, followed by the rear ones if applicable. Best to change the whole set if you can afford it though. (But we would say that wouldn’t we!!)
Yes. There is no legislative standard for replacement suspension bushes as the original components are not type-approved and this is recognised by TUV and KBA (Kraftfahrtbundesamt) in Germany, and therefore no permit is required.
Regardless of the vehicle, our parts are of equal quality and do the same job as required by the standard parts.
Our bushes only differ by design and colour but their function is the same. The quality of our Polyurethane parts matches the quality of the components which are or were used for the assembly of the motor vehicle in question as mentioned in article 1400/2002.
Tests have proven that our Polyurethane Suspension Bushes outperform and outlast their equivalent standard rubber items, proving their quality and suitability.
A letter from the Federal Motor Transport Authority dated November 23, 2022, can be found as a PDF download on this page.
The details of our unrivalled Lifetime Warranty are available here.
Contact Us for all your bush suspension solutions
We are very proud to be a certified ISO9001 company and receiver of the Queens’s Award for Enterprise and international trade 2013
2nd August 2018
NL2018-31 Range Rover EvoqueNew Products
This week we are expanding our range of parts for LR’s Compact SUV – the Range Rover Evoque.
Read more1st August 2018
Fast Ford July 18New Products
Fast Ford has featured our new Focus MK3 RS/ST Anti-Lift Kit (PFF19-1802G) in this month’s magazine
Read more