REMOVAL GUIDE
POWERFLEX suspension bushes are designed, in general, to be fitted by a home mechanic without the necessity for special tools.
The following video shows a typical way of removing and installing bushes with tools found in most home garages.
Bush Installation from Powerflex on Vimeo.
FITTING SINGLE-PIECE, DOUBLE-FLANGED COTTON-REEL TYPE BUSHES
1. Remove the original rubber bush from the arm, and clean any dirt and corrosion from the bore. Using a rounded file, remove any sharp edges from around the bore of the arm, creating a slight chamfer. Failure to do so will cause damage to the bush when pressing in.
2. Apply some washing-up liquid to the outside of the bush and bore of the arm to ease fitting. Press the polyurethane bush into the arm at an angle so one part of the lip is already in the bore of the arm, when the bush is then pushed in the rest of the lip will follow. Make sure the lip has fully popped out of the other side of the arm.
3. Apply some of the supplied grease to the bore of the bush and insert the sleeve.
4. Re-fit the arm to the vehicle and tighten all hardware to all manufacturer’s recommended torque settings.
Here is a video demonstrating the fitment of a bush of this style.
APPLICATION OF GREASE
The grease supplied with our bushes in the white sachet is our own formulated PTFE/Silicone bush assembly grease.
The key benefits of using this type of grease are,
It is used to optimise bush performance and durability.
To measure your Anti-Roll bar, there are two recommended methods.
If you have access to a Vernier Caliper then this is the most accurate way, however, using an open-ended Spanner can be just as effective.
By placing the open end of the spanner over the ARB and to the side of the rubber bush, you can gauge the size by simply moving up and down on the size until you find one that fits closely.
Whatever the size of the spanner is a good indication of the size of the ARB bush that you’d require. Simple!
A range of bushes engineered for the road to compliment your classic car.
Find out moreContact Us for all your bush suspension solutions
We are very proud to be a certified ISO9001 company and receiver of the Queens’s Award for Enterprise and international trade 2013
14th April 2016
NL2016-14 Alfa Romeo GTV/Spider 95-05New Products
Due to an increase in the popularity of the Alfa Romeo GTV and Spider 1995-2005, we have added some new parts to our catalogue for these vehicles.
Read more7th April 2016
NL2016-13 SAAB 9-3, VAUX/OPEL VECTRA CNew Products
This week we are adding front and rear subframe mounting bushes for the Saab 9-3 (2002-on) & Vauxhall/Opel Vectra C (2002 – 2008).
Read more